I finally completed all the trim and paint in my master bathroom remodel! It looks awesome! I am happy with every bit of it. Some of the final pictures below: Left side of the sink... [read more]

Shower door installed (I paid someone to measure and install it…it was much easier than me doing it myself): Cabinet doors and hardware installed. Waiting for the counter top to be fabricated…

I’ve been rather slow to update my blog. It is mainly for myself to remember what I did. After I finished the shower pan, I painted this red waterproofing membrane on the areas that might... [read more]

I’ve had this done a while…but here are some pictures of the bathroom cabinets and vanity. This is mainly for me to remember and look back on my blog and see what I did to... [read more]

Playing with tile options (ordered!) and still working on the bathroom remodel project. Cabinets have the finish applied, and I’m doing drywall work. Then plumbing…then tile.

I tore out the rest of the drywall, and removed the old bath tub. I then started redoing the electrical in prep for the new cabinet. The electrical switches were on the wrong side; they... [read more]

I finished my drawers; sprayed 4 coats of Target Coatings Water based lacquer on them. (EmTech 6000). It took a whole gallon to do them all..and ran out right at the end. These are mainly... [read more]

The bathroom remodel is a slow project when I do everything myself. Today I worked on finishing my drawers while also moving the plumbing for my sink. It’s hard to tell, but I cut out... [read more]

I want my bathroom cabinets to “float”. The top one floats 2″ in the air on top of the bottom cabinet, and the bottom cabinet floats 3″ in the air off the ground. The right... [read more]

Still working on stuff. Playing with stains; left side is 1/2 cherry ply, right is cherry wood. Bottom has a maple gel stain, top has pennsylvania cherry gel stain. Cutting all the face pieces to... [read more]

My woodworking project continues! I planed a bunch of maple to 5/8″ thick my drawer thickness. I went with 5/8″ instead of 3/4″, since my top drawers should appear more “dainty” as they are small.... [read more]

Tongue and groove practice; I have a height matched set. Note to self: Put the little rubber grommet inside the chuck. Place it on my table, and push the cutter into it until it bottoms... [read more]

I have been working on a new design for my master bathroom for quite some time. I finished in Sketchup recently: I’m going to be doing a “floating” design where the cabinets are supported by... [read more]