Bathroom Vanity: Taking Shape
My bathroom vanity is starting to finally look like something.
Here it is dry fitted before glue up:
The process will be to put one side on
The back, and then the other side:
Then lastly the front can be slid on. It went together pretty well!
Front door glue up didn’t go quite as well; I had some alignment issues. I forgot that the last time I made glued together doors I had made a right angle jig to clamp them too. This had allowed me to get everything aligned and clamped straight. The main problem I had here was I had flipped one board, so I had to pound it off and put it back on right — all while the glue was starting to set.
The drawer fronts are a solid piece of maple with a groove cut in with the router table:
Next step is to make the drawers. I milled the wood to ?” and then used my jig to cut some half blind dovetails:
Next I’ll run a ½” bottom groove for the drawer bottom. Then some sanding and glue up. Getting close to being done!
